Difference between revisions of "OMAX"
From DoyleGroup
(→OMAX Lists) |
(→OMAX Lists) |
||
| Line 8: | Line 8: | ||
== OMAX Lists== | == OMAX Lists== | ||
| − | * [[OMAX:Training|Training]] | + | * [[OMAX:Training|Training]] - The things you should learn when getting a waterjet lesson |
| − | * [[OMAX:Startup|Startup]] A checklist of how to start up the machine and begin cutting | + | * [[OMAX:Startup|Startup]] - A checklist of how to start up the machine and begin cutting |
* [[OMAX:Troubleshooting|Troubleshooting]] | * [[OMAX:Troubleshooting|Troubleshooting]] | ||
* [[OMAX:Tips|Tricks and Tips]] | * [[OMAX:Tips|Tricks and Tips]] | ||
Revision as of 16:34, 7 August 2009
This page contains information relating to the OMAX waterjet cutter.
Important Safety Reminders
- DO NOT use the machine unless someone has trained you to use it properly
- NEVER put your hands near the nozzle if the pre-charge pump is on
- NEVER put your hands near the slats without wearing cut-resistant gloves
OMAX Lists
- Training - The things you should learn when getting a waterjet lesson
- Startup - A checklist of how to start up the machine and begin cutting
- Troubleshooting
- Tricks and Tips
OMAX Purchasing
Talk to Steve, Nick, or Widagdo about purchasing waterjet stuff.
- Garnet: Garnet abrasive is purchased from Barton Mines. Call Stephen Podnorszki at (800) 741-7756, ext. 252. The cost is roughly 0.25/lb, and we order 1 ton at a time.
- Clamps: The clamps used to hold parts in the basin are called Quick-Grip Bar Clamps/Spreaders. They can be ordered from McMaster (see last section of link)
- Waterjet Parts: Nozzles, mixing disks, jewels, foam muffs, etc. can be ordered directly from OMAX.
- Sacrificial Material: Any material will do, so a cheap alloy of aluminum may be your best bet. Item 88685K51 from McMaster is good, for example.
