Difference between revisions of "OMAX:Startup"

Revision as of 09:07, 7 August 2009

OMAX Startup/Cut/Shutdown Checklists

• Machine Startup
  • Put a medical card in your pocket
  • Turn on water supply
  • Turn on air supply and check pressure = 75-80 PSI
  • Turn on electrical and startup computer
  • Turn on pre-charge pump
    • Check filter pressures = ~120 PSI, differential < 20 PSI
  • Rotate nozzle slightly
    • Counter-clockwise with respect to you looking down on nozzle
  • Check if you have to rotate jewel slightly
    • Counter-clockwise with respect to looking at top of jewel
• Programming Setup
  • Clean up drawing
  • Double-check tool path!
• Cutting Setup
  • Turn off pre-charge pump or move nozzle far out of the way before putting your hands in the cutting region!
  • Clamp your piece in place
    • Use extra pieces of stock if the clamps are not long enough
    • Do not clamp too tightly – can cause part to bow and hit nozzle
    • Use sacrificial material if finish matters
    • Be careful not to cut your hands on the slats
  • Move the nozzle to the path starting point and set Z zero – 60 mil above sample
  • Make a home point and set the path start home
  • Raise nozzle, put on muff, then return to Z zero
  • Check material type and thickness
  • Have nozzle move to extents, or do a dry run
  • Turn on pre-charge pump
  • Raise water level to about half-way up the muff
    • Place hand on piece near edge to make sure it stays in place
  • Warn bystanders if necessary
  • Start cut
• Machine Shutdown
  • Clean out the muff
  • Clear temporary homes
  • Shut down computer
  • Turn off SRS
  • Turn off electrical, water, air
  • Return medical card
  • Spray down the machine and put tools and stock away
  • Don't forget your USB drive!